عنوان المقالة:تقنية الصهر التدويمي كعملية تشكيل مستدامة لانتاج اشرطة رقيقة جدا من سبائك الالمنيوم-المغنيسيوم 5083 و 5052 Single Roll Melt Spinning Technique Applied as a Sustainable Forming Process to Produce Very Thin Ribbons of 5052 and 5083 Al-Mg Alloys Directly from Liquid State
أ.د. علي سبع حمود | Professor Dr. Eng. Ali Sabea Hammood | 9381
نوع النشر
مجلة علمية
المؤلفون بالعربي
د.احمد كاظم جاسم+ د. علي سبع حمود
المؤلفون بالإنجليزي
Ahmad K. Jassim and Ali S. Hammood
الملخص العربي
تقنية الصهر التدويمي كعملية تشكيل مستدامة لانتاج اشرطة رقيقة جدا من سبائك الالمنيوم-المغنيسيوم 5083 و5052
الملخص الانجليزي
In this paper, single roll melt spinning technique is used as a sustainable manufacturing process to reduce waste, time, energy, and cost. The nonconventional forming machine is manufacturing to produce very thin ribbon of 5052 and 5083 Al-Mg alloys in the range of micrometer. It is a tool for modifying the microstructure of alloy and improved their properties. The process has a direct impact for saving materials, machine, method, men, and money (5M) compared with conventional forming technology due to their ability to produce very thin ribbons directly from liquid state. The properties of the produced ribbons were investigated and the result indicating that there is a possibility to produce ribbons with micro thickness of 20 to 330 µm and width of 0.97 to 7.4 mm. Moreover, the hardness was improved to be more than twice of the original hardness of alloy. The corrosion resistance of alloy was improved and their rate was reduced.
تاريخ النشر
31/07/2016
الناشر
Procedia CIRP - ELSEVIER-Clarivate Analytics
رقم المجلد
40
رقم العدد
ISSN/ISBN
2212-827
رابط DOI
10.1016/j.procir.2016.01.079
الصفحات
133-137
رابط الملف
تحميل (404 مرات التحميل)
رابط خارجي
https://www.sciencedirect.com/science/article/pii/S2212827116000949
الكلمات المفتاحية
Keywords: Sustainability; Manufacturing; Melt Spinning; Al-Mg Alloys; Forming.
رجوع