عنوان المقالة:دراسة تجريبية للسلوك ثني الحزم الخرسانية المفرطة التعزيز المقوى بالصفائح الفولاذية المضغوطة ببراغي : ج I Experimental Study on the Flexural Behavior of over Reinforced Concrete Beams Bolted with Compression Steel Plate: Part I
شذى الاسدي | Shatha Alasadi | 7150
نوع النشر
مجلة علمية
المؤلفون بالعربي
شذى الاسدي - بيام شافعي - زينا ابراهيم
المؤلفون بالإنجليزي
Shatha Alasadi, Payam shafigh, Zainah Ibrahim
الملخص العربي
: الغرض من هذه الدراسه هو التحقيق في سلوك الانحناء لتعزيز شعاع الخرسانة المفرط التعزيز بواسطة صفيحة فولاذية مضغوطة براغي BCSP مع عوارض خرسانية تحت ظروف تجريبية مختبرية. تم اختبار ثلاثة عوارض مطورة بألواح فولاذية حتى فشلت في الانضغاط مقارنة بحزمة واحدة بدون لوحة فولاذية. كانت سماكة الألواح الفولاذية المستخدمة 6 مم و 10 مم و 15 مم. تم دعم الحزم وتحميلها بشكل رتيب بأحمال من نقطتين. وقد لوحظت سلوكيات انحراف الحمل للحزم وتحليلها وتقييمها من حيث التحميل الخرساني المتقطع ، وتحميل الذروة ، والإزاحة في منتصف المدة ، وصلابة الانحناء (الخدمة وما بعد الذروة) ، وتبديد الطاقة. تظهر نتيجة التجربة أن استخدام لوحة فولاذية يمكن أن يحسن أوضاع فشل الحزم ويزيد أيضًا من ذروة الحمل وصلابة الانحناء. تبدد عوارض تطوير الصلب طاقات أعلى بكثير مع زيادة في سمك اللوح مقارنة بالشعاع التقليدي.
الملخص الانجليزي
The purpose of this paper is to investigate the flexural behavior of over-reinforced concrete beam enhancement by bolted-compression steel plate (BCSP) with normal reinforced concrete beams under laboratory experimental condition. Three beams developed with steel plates were tested until they failed in compression compared with one beam without a steel plate. The thicknesses of the steel plates used were 6 mm, 10 mm, and 15 mm. The beams were simply supported and loaded monotonically with two-point loads. Load-deflection behaviors of the beams were observed, analyzed, and evaluated in terms of spall-off concrete loading, peak loading, displacement at mid-span, flexural stiffness (service and post-peak), and energy dissipation. The outcome of the experiment shows that the use of a steel plate can improve the failure modes of the beams and also increases the peak load and flexural stiffness. The steel development beams dissipated much higher energies with an increase in plate thicknesses than the conventional beam.
تاريخ النشر
23/01/2020
الناشر
MDPI- Applied Sciences
رقم المجلد
10
رقم العدد
3
ISSN/ISBN
2076-3417
رابط DOI
https://doi.org/10.3390/app10030822
الصفحات
822
رابط خارجي
https://www.researchgate.net/profile/Shatha_Al-Asadi
الكلمات المفتاحية
over-reinforced; bolting; BCSP; energy dissipation; steel plate; flexural stiffness
رجوع